Features

FEATURES/BENEFITS

For individuals looking to take it on a trip/travel.

For individuals looking for convenient, non-bulky chair they can depend on.

The Easy -go breaks down into three easy to handle pieces

The heaviest part of the unit is only 35 lbs!

Portable with excellent maneuverability inside and outside the home.

Travel is made simple with Easy-go

The EZ GO P321 electric wheelchair is small in size but large in style and comfort. Used for both indoor and outdoor travels, this petite power wheelchair is yet another addition to the Merits line of power wheelchairs. Small in stature, large in quality and can accomodate individuals that weigh up to 250lbs. Power wheelchairs

Specifications

Specification	Data
Maximum Speed	4 MPH
Weight Capacity	250lbs
Turninig Radius	23.3"
Ground Clearance	2"
Range up	9 mi.
Battery	2 x 10AMP
Battery Weight	7.3lbs
Front Wheel size	6" solid tires
Rear wheel size	8" solid tire
Battery charger	4 AMP off board
Brakes	Regenerative electronic brakes
Heaviest piece	34.3lbs

Seat Sizes	Data
Seat width	18"
Overall width	22.8"
Overall length	26.3
Seat Height from Deck	13.4"-17"
Seat Height from Ground	18.7"-20.7"
Seat width with arms	27lbs
Front frame with battery - Heaviest piece	34.3lbs
Rear frame with Motor	32.1lbs

Warranty:

1 year on electronics & Motors

Extra Images

Warranty

1 year Manufacturers warranty on Motor and Electronics

6 Months Warranty on Batteries

Optional Labor service Warranty

Measure Guide

Wheelchair/Powerchair measuring Guide

Hip Width: Use this to figure seat width if it is the widest point. Widest Point: Measure the widest area across the lower extremities if different from the hip width. This may influence seat width or arm style. Chest Width: Measure the widest point of the thorax just below the arm pit. This measurement may influence system width or back width. Heel to Knee: Use this for legrest extensions and seat height. SRP to Knee (Seat Reference Point to Knee): This will determine the seat depth. Elbow to SRP (Elbow to Seat Reference Point): Measure this width with the arm in a 90 degree angle at the elbow and the shoulder in a neutral position. Shoulder HeightSeat back height This will determine the height and the style of the back panel or the start for a custom back. Head Height: This will help determine the proper headrest height.

Seat Width: Diagram #

To determine the proper seat width, measure the width of your body from hip to hip (outside hip) while seating down. Please be sure to add an extra inch or so to allow for bulky clothes if relevant.

Seat Depth: Diagram #

To determine the appropriate depth measure from the most posterior point of the body to the inside of your knee. Please be sure to remove at least 2 inches. This helps to allow for a more relaxed posture and also some individuals may prefer additional leg overhang to make room for their hand when lifting their leg.

Seat Back Height: Diagram #

This is measured from the seat base to the top of the chair back. Often users of power chairs need upper back support. Our standard medium back support works fine.

Front seat to Floor

Measure the leg from the back of the knee to the sole of the foot. Then subtract the thickness of the cushion when it is compressed. Next, add a minimum of two inches for footrest clearance. Do not add the footrest clearance if the chair will be foot-propelled