Features

Back angle and height adjust for maximum comfort and support.

Nylon upholstery, 8-amp charger, Waterfall arm pads, Invacare MKIV-RII electronics

Portable crossbrace frame folds to 13 for transport.

Powerful 350-watt, high torque motors to ensure dependalbe performance; 250-lb. weight capacity

Telescoping front riggings allow optimal foot placement.

Specifications

Specification	Data
Maximum Speed	4 MPH
Weight Capacity	250lbs
Turninig Radius	33"
Ground Clearance	3.5"
Estimated Range up	up to 19 mi.
Battery	12V, U1 Batteries
Maximum Grade Incline	9°
Front tires	8" x2"
Rear tires	12.5 x2.25"
Battery charger	5A off board
Brakes	Regenerative electronic brakes
Total Weight	155 lb (with 22NF batteries) 85 lb (w/o batteries & front riggings)

Seat Sizes	Data
Seat width	14" - 20"
Overall width	20" - 26"
Overall length	40.75"
Seat back Height	16" - 19"
Seat to floor height	17.75" - 19.75"
Overall Height	35" - 38"
Seat Angle	3° fixed
Back Angle	5°-+20° (5° increments)
Seat Style	Sling Style

Warranty

Base Frame:3 years

Seat Frame: 3 years

Electrical Components: 1 year

Motors: 1 year

Batteries: 6 months

Remaining components(except upholstered materials, padded materials, tires/wheels): 1 year

If you experience a problem with your power wheelchair please contact us and one our representatives will assist dispatching a technician to you.

Measuring Guide

Wheelchair/Powerchair measuring Guide

Hip Width: Use this to figure seat width if it is the widest point. Widest Point: Measure the widest area across the lower extremities if different from the hip width. This may influence seat width or arm style. Chest Width: Measure the widest point of the thorax just below the arm pit. This measurement may influence system width or back width. Heel to Knee: Use this for legrest extensions and seat height. SRP to Knee (Seat Reference Point to Knee): This will determine the seat depth. Elbow to SRP (Elbow to Seat Reference Point): Measure this width with the arm in a 90 degree angle at the elbow and the shoulder in a neutral position. Shoulder HeightSeat back height This will determine the height and the style of the back panel or the start for a custom back. Head Height: This will help determine the proper headrest height.

Seat Width: Diagram #

To determine the proper seat width, measure the width of your body from hip to hip (outside hip) while seating down. Please be sure to add an extra inch or so to allow for bulky clothes if relevant.

Seat Depth: Diagram #

To determine the appropriate depth measure from the most posterior point of the body to the inside of your knee. Please be sure to remove at least 2 inches. This helps to allow for a more relaxed posture and also some individuals may prefer additional leg overhang to make room for their hand when lifting their leg.

Seat Back Height: Diagram #

This is measured from the seat base to the top of the chair back. Often users of power chairs need upper back support. Our standard medium back support works fine.

Front seat to Floor

Measure the leg from the back of the knee to the sole of the foot. Then subtract the thickness of the cushion when it is compressed. Next, add a minimum of two inches for footrest clearance. Do not add the footrest clearance if the chair will be foot-propelled