Travel Power wheelchairs - Invacare - At'm Take Along Power Wheelchair

Home | Power Wheelchairs » Travel Power wheelchairs » At'm Invacare At'm Take Along Power wheelchair

Invacare At'm Take Along Power wheelchair [At'm]

Wherever you're going, At'm electric wheelchair goes too. It took Invacare to create the power wheelchair lightweight and compact enough to fit in the trunk of a car. Simple enough to assemble in 60 seconds. Powerful enough for a full day of adventure. Buy this Power wheelchair today and be sure you will have your wheelchair with you everywhere you go. Owners Manual At'm Brochure

$1,749.40

Features
Specifications
Warranty
Measuring Guide

Features

The lightweight characteristic of the At'm allows for easy transport in almost any vehicle.

Carefully designed cushioning and breathable fabric provide hours of seating comfort. Folds like a lawnchair and weighs just 14 lb.

The sturdy but lightweight base - just 34 lb. - is designed for stability

The Gearless Traction Control drive system gives you the performance to drive confidently. For situations when pushing At'm is preferred, simply lift the drive disengagement levers.

The 17 amp hour batteries give up to 12 miles of continuous use.

Specifications

Specification	Data
Maximum Speed	0-4 MPH
Weight Capacity	250lbs
Turninig Radius	22"
Ground Clearance	2"
Estimated Range up	10-12 mi.
Battery	12V, 17AH Batteries
Maximum Grade Incline	6°
Front tires	1" x6"
Rear tires	2.25 x12.5"
Battery charger	3A off board
Brakes	Regenerative electronic brakes
Base Section Weight	34lbs
Seat and Arms Weight	14lbs
Battery Pack	26lbs
Total Weight	74lbs

Seat Sizes	Data
Seat width	18"
Overall width	25.5"
Overall length	35.5"
Seat back Height	18", 21"
Seat depth	15"
Overall Height	33"
Seat Height	n/a"
Seat Style	Sling Style

Warranty

Base frame: 36 months

Seat frame: 36 months

Electronics: 12 months

Motor/gear: 12 months

1 Year In Home Service Labor

Measuring Guide

Wheelchair/Powerchair measuring Guide

Hip Width:
Use this to figure seat width if it is the widest point.

Widest Point:
Measure the widest area across the lower extremities if different from the hip width. This may influence seat width or arm style.

Chest Width:
Measure the widest point of the thorax just below the arm pit. This measurement may influence system width or back width.

Heel to Knee:
Use this for legrest extensions and seat height.

SRP to Knee (Seat Reference Point to Knee):
This will determine the seat depth.

Elbow to SRP (Elbow to Seat Reference Point):
Measure this width with the arm in a 90 degree angle at the elbow and the shoulder in a neutral position.

Shoulder HeightSeat back height
This will determine the height and the style of the back panel or the start for a custom back.

Head Height:
This will help determine the proper headrest height.

Seat Width: Diagram #
To determine the proper seat width, measure the width of your body from hip to hip (outside hip) while seating down. Please be sure to add an extra inch or so to allow for bulky clothes if relevant.

Seat Depth: Diagram #
To determine the appropriate depth measure from the most posterior point of the body to the inside of your knee. Please be sure to remove at least 2 inches. This helps to allow for a more relaxed posture and also some individuals may prefer additional leg overhang to make room for their hand when lifting their leg.

Seat Back Height: Diagram #
This is measured from the seat base to the top of the chair back. Often users of power chairs need upper back support. Our standard medium back support works fine.

Front seat to Floor
Measure the leg from the back of the knee to the sole of the foot. Then subtract the thickness of the cushion when it is compressed. Next, add a minimum of two inches for footrest clearance. Do not add the footrest clearance if the chair will be foot-propelled

This product was added to our catalog on Thursday 18 June, 2009.